Emacspeak discussion list

[Victor Tsaran <vtsaran AT gmail.com>]

Hello.
I am on Mac OS running Emacspeak 58.0 with Emacs 29.x.
A week or so ago, after doing who knows what to my machine, I started getting 
what sounds like escape sequences in the speech output produced by Emacspeak 
when using shell, (m-x shell). Prior to the incident, whatever it was, I was 
able to run terminal applications inside the shell, send input and get output 
with no problems. However, now I am hearing left-bracketed utterances and 
only the last character of the shell prompt, e.g. “%” after issuing a 
command. What’s worse though is that I am not able to successfully send any 
input to a terminal application. The input gets echoed but is not parsed by 
the running terminal application.
I reinstalled Emacs and Emacspeak but to no avail. I reduced my init file to 
a bare minimum so that only Emacspeak loads.
I tried changing encoding input/output parsing via c-x ret, then “c”, “t” or 
“p. Still no luck.
I doubt the issue is with Emacspeak, but not sure where else to look and what 
I have changed to cause the behavior.

Any ideas by any chance?
Thanks so much!
Victor